Ribbon Fish,Frozen Ribbon Fish Steak,Hairtail Steak Dingshengyuan Trade Co., Ltd. , http://www.fj-foods.com
Use and maintenance of small harvesters
1. Maintenance and maintenance of the harvester 1. Inspection: Check and repair the cutter of the harvester, check whether the movement of the movable and stationary blades is flexible, whether there is warping damage, check whether the cutter guard is damaged, and repair the damaged parts. Or replace it and adjust it to restore the machine to its normal state. Check the transmission parts. Check the tightness of the conveyor belt for damage and proper operation. 2. Cleaning: Clean the dust, weeds and other debris of the harvester regularly to keep the machine clean and ensure the normal operation of the machine. 3. Lubrication: Lubricate all moving parts as required. Second, use and safe operation 1. Before use, should turn the drive shaft by hand, check whether each part is flexible, and then run at low speed for 10-15 minutes. 2. It is forbidden to carry out inspection, maintenance, adjustment and maintenance while the equipment is in operation. 3. When harvesting, determine the reasonable working speed based on the crop production density. Then, after the harvester is operated to this speed, it will be harvested and straightened as far as possible so that the tiller will not overwhelm the crop. 4. Determine the harvesting direction according to the crop lodging situation, wind direction, plot size. In general, lodging should be carried out against the wind. 5. If it is found that there is dew in the morning or evening, or when the crop is wet after the rain, harvesting should not be carried out to avoid damage to the implement. 6. Clean the weeds and soil in time in order to avoid blocking the knife and affect the operation. 7. According to the ground conditions, determine the cutting height; when encountering obstacles such as ditch, pit, and stones, raise the header. 8. When transferring plots and transportation, the harvester should be set up and the tractor run at low speed. 9. When the work is stopped and stopped, the harvester should be put down to prevent accidents. 10. After the harvester is used, it should be supported and lubricated. It should be parked in the storage shed to prevent wind and rain, and the natural rust will cause damage. China Agriculture Network was compiled from Agricultural Science and Technology News.-2005.6.3.-3