Insert pad are a disposable product that can be easily changed without washing.Some of the super absorbent core layers are composed of polymer absorbers and villi.Absorb quickly and fully, effectively condense without infiltration, ensure anti-seepage and anti-leakage, make users dry and cool at any time.At the same time the use of leakproof elastic pants edge, unique U-shaped design, gently wrapped around the legs, effectively prevent urine leakage side, no matter what the circumstances are dry and clean.Arc draping, and considerate body.It also has soft, dry and non-woven fabric surface with good air permeability, which makes users feel comfortable and natural at any time. Insert Pad,Disposable Insert,Attends Insert Pads,Diaper Liners Shandong Kangshun Daily Products Co., Ltd , https://www.centurybenifit.com
*The bottle rail is loose and the rail bolts need to be tightened.
* The "â”»" type nylon pad on the bottom of the chain is seriously worn, and the middle protrusion of the pad is higher than the chain, and the pad needs to be replaced.
* There is broken glass between the tracks, which needs to be removed.
2, the bottle is poured into the bottle table * there is broken glass between the rails, need to be removed.
*The transition plate is seriously worn, and the transition plate 3 needs to be replaced. The chain is beaten, the bottle is not inserted, the pitch of the chain is increased, the length of the chain is elongated, or the nylon wheel is worn. The chain or nylon wheel needs to be replaced.
4, push the bottle refers to the bottle, turn the bottle * push the bottle refers to burrs or severe wear, need to replace the push bottle finger.
*The push bottle is loose and the bolts need to be tightened.
* There is broken glass between the bottle entrance rails, need to be removed 5. The top bottle in the bottle box * There is broken glass in the bottle box, which needs to be removed.
*The bottle box is damaged and the bottle box needs to be replaced.
* Pushing the bottle means loose or worn, causing the push bottle to be out of position, tightening or replacing the push bottle finger.
6. Front clutch failure * The clutch plate is loose, the fastening bolt 7, the BL pump does not work or the flow rate is small. * The diaphragm valve is damaged. The diaphragm valve is replaced. * The diaphragm bottom valve is seriously worn. The diaphragm bottom valve is replaced. The WWS pump does not work or the flow rate is small. *The membrane valve is damaged, the membrane valve is replaced. *The membrane bottom valve is seriously worn. The membrane bottom valve is replaced. *The display is out of order. The repair monitor* manually adjusts the flow rate. 9. In addition to the standard mesh jumper*, the drive wheel is seriously worn, and the drive wheel is replaced. Long, go to a few short sections or replace the standard net * There is a hard object stuck in the track, clear the track 10, remove the standard net trip * there is a hard object stuck in the track, clear the track * bad effect of the standard removal, block the mesh, will In addition to the standard net flushing or replacement of the standard brush 11, the bottle is poured out of the bottle * the bottle cam has burrs or cam loose, deformation, need to remove burrs or tighten, replace the cam * bottle plate dislocation, restore adjustment * bottle There are broken glass or other sundries, need to be removed 12, bottle out of the bottle * slip into the inside of broken glass or other debris, need to be removed * loose bolts above the slide, tightening * serious wear of the slide, replace the slide
Introduction to the common faults and troubleshooting methods of bottle washers
1. The bottle entering the bottle is not smooth. * The gap between the bottles and the track is small, and the track clearance needs to be adjusted.
Next Article
Young chickens cannot feed protein feed
Prev Article
Which plants can't feed rabbits