Slurry separator use method: installation Set the machine to a stable position and turn on the power according to the calibration voltage of the motor nameplate. Note: The grounding wire must be securely installed! Soaking of raw materials Remove hard materials from the material and soak them in cold water or below 40 degrees until the material has no hard core. Slurry separator start Loosen the nut of the upper handle, rotate the handle in the direction of the signboard, and gently push the filter frame at the slag mouth. There is no resistance, no click, and the rotation can be flexible to start the machine. After idling for several tens of seconds, slowly Rotate the handle in the direction of the sign. When you hear the uniform click of the machine, tighten the lock nut, add the soaked material to the hopper, and adjust the water flow to the desired pulping concentration. If the slag is thick, the handle can be finely adjusted in a fine direction, but do not adjust the slag too fine, the fine slag skin will easily block the filter mesh, and there will be slurry in the slag. If the slag is thick after grinding, add water and grind. Slurry separator shutdown and cleaning: When there is no material in the hopper, the slag outlet will stop and stop water when there is no slag discharge. After the machine is completely stable, remove the cover, unscrew the disc nut, remove the grinding wheel and filter frame, wipe the inside and outside of the machine with a rag, wash the parts with water, and then install the machine as it is, so that the next Use once. Slag separator Note: When loading, be sure to press the original position, the positioning of the side of the grinding wheel and the positioning screw on the filter frame, and the marking hole at the bottom of the filter frame and the marking column of the coupling. Fiberglass safety helmet Fire Safety Helmet,Work Safety Helmet,Fiberglass Safety Helmet,Construction Safety Helmets Shandong Binzhou Yong'an Labor Protection Factory , https://www.zhuqiangsafetybelt.com
Slurry separator use method and precautions