First, the use of the returning machine: 1. During operation, the machine should be raised to a height of 20-25 cm above the ground. Ensure that the lifting height is not too high, as this could cause excessive joint angles and potentially damage the machine. Turn the power output shaft for 1-2 minutes before engaging the work block. Slowly release the clutch pedal (if using a Tigris-55 model, a two-stage clutch must be used), while simultaneously adjusting the hydraulic lift control lever. Gradually lower the returning machine to the desired working height, then increase the throttle and proceed with normal operations. 2. While working, avoid allowing the hammer claws to hit the soil, as this can cause an unexpected increase in torque and lead to mechanical failure. If you notice the hammer claw striking the ground, adjust either the machine’s height or the length of the tractor's suspension rod to prevent further issues. 3. Before turning, raise the turning machine and wait until the turn is completed before resuming work. When lowering the machine after a turn, ensure stability to prevent any backward movement during operation. When transporting on roads, always disengage the tractor’s power take-off (PTO) system. 4. During operation, make sure to clear any grass or debris that may wrap around the machine. Avoid obstacles such as rocks, tree stumps, or uneven terrain. Always leave a 3-5 meter space in front of the unit for safe turning and maneuvering. 5. If you hear any unusual noises during operation, stop the machine immediately. Inspect and resolve the issue before continuing to operate to prevent further damage. 6. Regularly check the tension of the drive belt during operation. A loose belt can reduce the speed of the cutter shaft, affecting the quality of the cutting and increasing wear on the belt. Second, safety operation and precautions: 1. The operator should thoroughly understand the machine’s functions and follow the manufacturer’s instruction manual when operating it. 2. Before use, fill the gearbox with 30# gear oil. The oil level should cover approximately one-third of the oil surface to ensure proper lubrication and cooling. 3. When installing the universal joint, pay attention to the following three key points:
A. Ensure that when the equipment is lifted, the square shaft and its housing are not locked, and there is enough clearance between the cross and the ends.
B. Install the universal joint in the correct position and direction. Incorrect installation can result in loud noises, strong vibrations, and potential damage to the joint.
C. When using the 55 or 60 hens of Tien Niu, replace the cylinder’s fixed support rods with flat iron plates to prevent collisions between rotating joints. 4. Never operate the machine if the alignment is incorrect or if there is excessive play in the system. This can lead to serious mechanical problems and safety hazards. By following these guidelines, operators can ensure smooth, efficient, and safe operation of the returning machine, while also extending its lifespan and reducing maintenance costs. Female Internal Genital Model,Human Brain Anatomy Model,Larynx Heart And Lung Model,Liver Pancreas And Duodenum Model Yinchuan Erxin Technology Co., LTD , https://www.exmedmodel.com
The use of straw smashing returning machine